1. Preparation before running-in of new oil press shaft
Before using the new shaft, it needs to be fully preheated. You can rotate the shaft for 30-60 minutes first, and wait until the surface temperature of the shaft rises to 1/3 of the room temperature before formally running-in. In addition, you should also ensure that other parts of the oil press are operating normally to avoid abnormal friction and shaft wear.
2. Appropriate load to ensure reasonable running-in of the shaft
During the running-in process, an appropriate load is required to ensure reasonable running-in of the shaft. It is recommended to use 1-2% of oil press material and gradually increase the load to adapt to the load capacity of the shaft. Do not put in too much oil press material at one time to avoid overloading and accelerating shaft damage.
.jpg)
| Models |
MK60 |
MK1685 |
MK1688 |
MK120 |
MK50 |
| Power |
Main engine |
2.0 kw |
3kw |
3.5 kw |
4kw |
| Vacuum pump |
4x-3kw |
6x-5.5kw |
6x-7.5kw |
6x-11kw |
6x-30kw |
| Heater |
2.0kw |
3kw |
3.5kw |
4kw |
5kw |
| capacity |
40-50kg/h |
80-160kg/h |
150-260kg/h |
260-400kg/h |
450-550kg/h |
| Whole weight |
270kg |
550kg |
760kg |
915kg |
1550kg |
| Outside dimension |
1350*950*1170mm |
1700*1300*1600mm |
2000*1350*1750mm |
2050*1400*1800mm |
2450*1980*1770mm |
3. Gradually increase the load to improve the load capacity of the shaft
During the operation of the oil press, gradually increase the load to allow the shaft to continuously adapt to higher loads. During the specific operation, you can first adjust the oil press to about half load, and then slowly increase the feed volume and pressing force until the normal working load is reached.
4. Maintain lubrication to extend the service life of the shaft
During the operation of the oil press, it is very important to maintain lubrication. You can add an appropriate amount of lubricating oil to the operating part of the shaft to reduce the wear of the shaft and extend its service life. In addition, you should frequently check the lubrication of the shaft and replenish the lubricating oil in time to ensure that each part can be fully lubricated.
The above are some tips for the running-in of the new pressing shaft of the oil press, I hope it can help you. When using the oil press, you must pay attention to the running-in and lubrication of the shaft to ensure the efficiency and durability of the machine.
.jpg)
.jpg)
